Lino Down

Hi Guy's,

Just a quick update nearly there now I cut and fitted the Lino today. It has a small tile effect like a roman mosaic. I made up a template from lining paper and using a marking block I transferred the outline onto the lino. I cut this out leaving a bit of spare that could be trimmed back when in place.

After I had trimed it to fit I rolled it back halfway across the floor and applied a contact floor tile adhesive to the floor using a spreader. This was left for 30 minutes to go tacky then the lino was rolled back down and smoothed out.

The other side was rolled up to the glue point and the whole process was repeated. Then a bead of silicon bathroom sealer was run around the edges to prevent water from finding it's way underneath.
It looks quite good just got to make a bath panel and its done one room finished.

That about it folks.

KBO.